Residual Strength Parameter Method for Slope stability on a Toll Road with Expansive Clay

Authors

  • Goji Pamungkas Department of Civil Engineering Diponegoro University, Jalan Prof Sudharto SH Semarang, Central Java, Indonesia.
  • Thomas Triadi Putranto Department of Geological Engineering Diponegoro University, Jalan Prof Sudharto SH Semarang, Central Java, Indonesia.
  • Suharyanto Department of Civil Engineering Diponegoro University, Jalan Prof Sudharto SH Semarang, Central Java, Indonesia.
  • Muhrozi Department of Civil Engineering Diponegoro University, Jalan Prof Sudharto SH Semarang, Central Java, Indonesia.
  • Yanuar Niko Priambodo PT Waskita Karya Batang Semarang Toll Road Project, Semarang, Central Java, Indonesia.

DOI:

https://doi.org/10.25299/jgeet.2022.7.2.9251

Keywords:

residual, expansive, clay, slope, stability, toll-road

Abstract

The decreasing stability phenomenon needs to be considered during the design of cut slopes on problematic soil. Excavation slope of toll road construction tends to fail when it lies above clay-shale strata. Certain common correlations and ordinary analytical methods are not recommended for safety calculation. This study is intended to find out the characteristic of clay-shale and proper slope inclination design on Semarang Batang Toll Road. The behaviour of a clay-shale area on the cut slope of Batang-Semarang toll road segment STA 438+000–STA 439+000 was identified. The degradable and expansive properties caused slope failure of the initial design with an inclination of 1 H: 1 V. Laboratory tests found that the soil had a clay faction > 40% and can be categorized as high plasticity (LL > 50%). An empirical approach determined that the residual shear strength decreased to phi < 6 degrees. To describe the swelling after the excavation stage, the flow deformation was determined by a finite element simulation. During the swelling phase, the pore water pressure was maintained at a certain value, and a gentler slope fulfilled the minimum safety factor with an inclination of 1 V: 3 H. Furthermore, the shear strength of the clay-shale was reduced to that for a fully softened material, and all the slope factors for safety moved to a critical state. According to the simulation, the minimum suggested slope inclination is 5 H: 1 V. This approach is important for the maintenance of pore water pressure and the prevention of an additional reduction in the shear strength so as to avoid slope failure on clay-shale regions in the yielding stage.

Downloads

Download data is not yet available.

References

Alatas, I., Kamaruddin, S., Nazir, R., & Irsyam, M. (2015). Shear strength degradation of Semarang Bawen clay shale due to weathering process. Jurnal Teknologi Universiti Teknologi Malaysia, 77(11).

Badan Standardisasi Nasional. (2018). SNI 8460:2017 Persyaratan perancangan geoteknik. Jakarta: Badan Standardisasi Nasional.

Bell, F. (1978). Foundation Engineering in Difficult Ground. London: Butterworth-Heinemann Ltd.

Boggs, Jr, S. (2009). Petrology of Sedimentary Rock (2nd Edition ed.). New York: Cambridge University Press.

Chao, K., Kang, J., & Nelson, J. (2014). Challenges in Water Migration Modeling for Expansive Soils. Soil Behavior and Geomechanics, 204-213.

CND Geoteknika. (2018). Laporan Investigasi Geoteknik Jalan Tol Semarang - Batang Seksi 4 - 5 Simpang Susun Kaliwungu. Bandung: CND Geoteknika.

Gartung, E. (1986). Excavation of The Hard Clays of The Keuper Formation. Proc Symposium on Geotechnical Aspects of Stiff and Hard Clays. 24, hal. 69–83. Seattle: International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts.

Irsyam, M., Susila, E., & Himawan, A. (2006). SLOPE FAILURE OF AN EMBANKMENT ON CLAY SHALE AT KM 97+500 OF THE CIPULARANG TOLL ROAD AND THE SELECTED SOLUTION. International Symposium on Geotechnical Engineering, Ground Improvement and Geosynthetics for Human Security and Environmental Preservation, (hal. 531-540). Bangkok.

Knappett, J., & Craig, R. (2012). Craig's Soil Mechanics (8th Edition ed.). Ofxordshire: Spon Press.

Li, P., Vanapalli, S., & Li, T. (2016). Review of collapse triggering mechanism of collapsible soils due to wetting.

Journal of Rock Mechanics and Geotechnical Engineering, 8(2), 256-274.

Neuendorf, K., Mehl Jr., J., & Jackson, J. (2011). Glossary of Geology (5th Edition ed.). Alexandria: American Geosciences Institute.

Onochie, K., & Rezaei, A. (2016). Special Considerations in Design of Foundation in Problematic Soils. Tirana: 3 rd International Balkans Conference on Challenges of Civil Engineering.

Pardoyo, B., Sadono, K., Fahreza, D., & Maulana, T. (2020). The Effect of Clay Shale Drying on the Reduction ofCompressive Strength and Durability in BawenSub-District, Semarang Regency. Civil Engineering and Architecture, 8(6), 1359-1369.

Postilla, H., Helmb, P., Dixona, N., Glendinning, S., Smethurstc, J., Rouainia, M., . . . Blake, A. (2021). Forecasting the long-term deterioration of a cut slope in high-plasticity clay using a numerical model. Engineering Geology.

Pratama, I. (2021). Studi Stabilitas Lereng Clay Shaledi Kalimantan dengan Menggunakan Metode Kesetimbangan Batas dan Pendekatan Probabilistik dan Deterministik. JURNAL REKAYASA KONSTRUKSI MEKANIKA SIPIL(JRKMS), 04(02), 103-113.

Putera, A., Pramusandi, S., & Damianto, B. (2017). Identification and classification of clayshale characteristic and some considerations for slope stability. African Journal of Environmental Science and Technology, 11(4), 163-197.

Qi, S., & Vanapalli, S. (2016). Influence of swelling behavior on the stability of an infinite unsaturated expansive soil slope. Computers and Geotechnics, 76, 154-169.

Renania, H., & Martin, C. (2020). Factor of safety of strain-softening slopes. Journal of Rock Mechanics and Geotechnical Engineering, 12(03), 473-483.

Rezaei, M., Ajalloeian, R., & Ghafoori, M. (2012). Geotechnical Properties of Problematic Soils Emphasis on Collapsible Cases. International Journal of Geosciences,, 03(01), 105-110.

Richardson , D. (1985). Relative Durability of Shale -- A Suggested Rating System. Proceedings of the 36th Annual Highway Geology Symposium . Clarksville: Indiana Department of Highways.

Sheng, D. (2011). Review of fundamental principles in modelling unsaturated soil behaviour. Computers and Geotechnics, 38(6), 757-776.

Skempton, A. (1964). Long-Term Stability of Clay Slopes . Géotechnique, 14(2), 77 - 102.

Stark, T., & Duncan, J. (1991). Mechanisms of Strength Loss in Stiff Clays. Journal of Geotechnical Engineering, 117(01), 139-154.

Stark, T., & Hussain, M. (2013). Drained Shear Strength Correlations for Slope Stability Analyses. Journal of Geotechnical Engineering, 139(6), 853-862.

Wilson, J., & Wilson, L. (2014). Clay Mineralogy and Shale Instability: An Alternative Conceptual Analysis. Clay Minerals, 49, 127–145.

Yulistiawati, W., & Zaman, M. (2018). A Study Upon The Behaviour of Clay Shale Soil of The Kerek Formation on The Excavation Work of Batang-Semarang Toll Road (Sec. Stat. 437+700 To Stat. 439+120). Semarang: Diponegoro University.

Downloads

Published

2022-06-30